In this small tutorial i will explain how to configure static ip address on CentOS 7Â minimal.
First, need to edit the set up for the ethernet. Let’s start with editing “/etc/sysconfig/network-scripts/ifcfg-enp0s3″ file:
|
1 |
vi /etc/sysconfig/network-scripts/ifcfg-enp0s3 |
|
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 |
HWADDR=08:00:27:6C:FF:91 TYPE=Ethernet BOOTPROTO=static DEFROUTE=yes PEERDNS=yes PEERROUTES=yes IPV4_FAILURE_FATAL=no IPADDR=192.168.0.88 IPV6INIT=yes IPV6_AUTOCONF=yes IPV6_DEFROUTE=yes IPV6_PEERDNS=yes IPV6_PEERROUTES=yes IPV6_FAILURE_FATAL=no NAME=enp0s3 UUID=ea68db6e-461e-427d-b9a8-bfcf6e1a4fc6 ONBOOT=yes |
Save and exit.
|
1 |
vi /etc/sysconfig/network |
|
1 2 3 |
NETWORKING=yes HOSTNAME=centos7 GATEWAY=10.1.1.253 |
|
1 |
vi /etc/resolv.conf |
|
1 2 |
nameserver 8.8.8.8 nameserver 8.8.4.4 |
|
1 |
/etc/init.d/network restart |
|
1 |
ip addr |
|
1 2 3 4 5 6 7 8 9 10 11 12 |
1: lo: <loopback,up,lower_up> mtu 65536 qdisc noqueue state UNKNOWN link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 inet 127.0.0.1/8 scope host lo valid_lft forever preferred_lft forever inet6 ::1/128 scope host valid_lft forever preferred_lft forever 2: enp0s3: <broadcast,multicast,up,lower_up> mtu 1500 qdisc pfifo_fast state UP qlen 1000 link/ether 08:00:27:6c:ff:91 brd ff:ff:ff:ff:ff:ff inet 192.168.0.88/24 brd 192.168.0.255 scope global enp0s3 valid_lft forever preferred_lft forever inet6 fe80::a00:27ff:fe6c:ff91/64 scope link valid_lft forever preferred_lft forever |